Panasonic CZ-ANC2 Instructions D'installation page 10

DIPSW1
Zone address switches
Use these to set the zone addresses.
1(Central Adress 1-16)
2(Central Adress 17-32)
3(Central Adress 33-48)
4(Central Adress 49-64)
ON/OFF controller main/sub selection switch
This is normally used at the main (OFF) setting.
When the ON/OFF controller is to be used by a main
unit and a sub unit (2 units) in one zone, set one unit to
main (OFF) and the other unit to sub (ON).
OFF: ON/OFF controller operates as main controller.
ON: ON/OFF controller operates as sub-controller.
• Set the zone address switch of the sub ON/
NOTE
OFF controller to the same address as the
main ON/OFF controller.
• One ON/OFF controller must always be set
as the main ON/OFF controller.
Central control main/sub selection switch
(OFF: main, ON: sub)
This is normally used at the main (OFF) setting.
Set it to sub (ON) when a communication adapter,
intelligent controller or system controller is to be used
concurrently.
Group inhibited/all indoor unit control permitted
selection switch
Use these to switch between the group inhibited and
all indoor unit control permitted statuses for each of the
four groups.
All indoor unit control permitted
1-16 Group inhibited
5-16 Group inhibited
9-16 Group inhibited
13-16 Group inhibited
All indoor run/stop selection switch
Use this to select the units to be run or stopped when
the ALL ON. or ALL OFF.O button has been pressed.
OFF : All indoor unit
ON: inhibited indoor unit
*All switches are OFF position at shipment.
10
1 2
OFF OFF
ON OFF
OFF ON
ON ON
5 6 7
OFF OFF OFF
ON OFF OFF
OFF ON OFF
ON ON OFF
OFF OFF ON
DIPSW1
ON
1 2 3 4 5 6 7 8
OFF
Fig. 5