TOSOT TW09HQ1B2DI Manuel Du Propriétaire page 64

Function introduction for combination buttons
Auto clean function
Under unit off status, hold "MODE" and "FAN" buttons simultaneously for 5s to turn on
or turn off the internal clean function. When the internal clean function is turned on, indoor
unit displays "CL". (This function is applicable for some models)
During the self-cleaning process of evaporator, the unit will perform fast cooling or fast
heating. There may be some noise, which is the sound of flowing liquid or thermal expan-
sion or cold shrinkage. The air conditioner may blow cool or warm air, which is a normal
phenomenon. During cleaning, please make sure the room is well ventilated to avoid
affecting the degree of comfort.
Note:
The self-cleaning function can only work under normal ambient temperature. If the room
is dusty, clean once a month; if not, clean once every three months. After the self-cleaning
function is turned on, you may leave the room. When self-cleaning is finished, the air
condition will enter standby mode.
8℃ heating function
Under heating mode, press "TEMP" and "CLOCK" buttons simultaneously to start
up or turn off 8℃
will be shown on remote controller, and the air conditioner keep the heating status
at 8℃ . Press "TEMP" and "CLOCK" buttons simultaneously again to exit 8℃
heating function.
Note:
● Under 8℃ heating function, fan speed is defaulted at auto speed and it can't be
adjusted.
● Under 8℃ heating function, set temperature can't be adjusted. Press "TURBO"
button and the remote controller won't send signal.
● Sleep function and 8℃ heating function can't operate at the same time. If 8℃
heating function has been set under heating mode, press sleep button will cancel
8℃ heating function. If sleep function has been set under heating mode, start up
the 8℃ heating function will cancel sleep function.
● Under ℉ temperature display, the remote controller will display 46 ℉ heating.
Child lock function
Press "▲" and "
child lock function is on, "
the remote controller, the "
the unit.
Temperature display switchover function
Under OFF status, press "
erature display between ℃ and ℉ .
I FEEL Function
Press "▲" and "MODE" buttons simultaneously to start I FEEL function and "
will be displayed on the remote controller. After this function is set, the remote
controller will send the detected ambient temperature to the controller and the unit
heating function. When this function is started up, "
" simultaneously to turn on or turn off child lock function. When
" icon is displayed on remote controller. If you operate
" icon will blink three times without sending signal to
" and "MODE" buttons simultaneously to switch temp-
17
" and "8℃ "
"