TOSOT TW09HQ1B2DI Manuel Du Propriétaire page 61

Introduction for buttons on remote controller
● When selecting "
louver will automatically swing up & down at maximum angle.
● When selecting " 、
● When selecting "
● Hold " " button above 2s to set your required swing angle. When reaching your
required angle, release the button.
Note:
" 、 、 " may not be available. When air conditioner receives this signal, the
air conditioner will blow fan automatically.
5
TURBO button
Under COOL or HEAT mode, press this button to turn to quick COOL or quick
HEAT mode. "
to exit turbo function and "
6
▲/ button
● Press "▲" or "
Holding "▲" or "
change quickly. On releasing button after setting is finished, temperature indica-
tor on indoor unit will change accordingly.
● When setting TIMER ON, TIMER OFF or CLOCK, press "▲" or "
adjust time. (Refer to CLOCK, TIMER ON, TIMER OFF buttons)
7
SLEEP button
Under COOL or HEAT mode, press this button to start up sleep function.
" " icon is displayed on remote controller. Press this button again to cancel sleep
function and "
8
TEMP button
By pressing this button, you can see indoor set temperature, indoor ambient temp-
erature or outdoor ambient temperature on indoor unit's display. The setting on
remote controller is selected circularly as below:
", air conditioner is blowing fan automatically. Horizontal
、 、 、
、 、
" icon is displayed on remote controller. Press this button again
" icon will disappear.
" button once increase or decrease set temperature 1℃(1°F) .
" button, 2s later, set temperature on remote controller will
" icon will disappear.
no display
14
" button to