Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

- After having positioned on the tyre the bead presser roller, lock the bead pressing clamp
on the rim near (at approximately 3-4cm from the disc - Fig. 34c).
- Rotate the wheel until the clamp is at 5 o'clock position and Check that the portion of
the tyre bead (between roller and clamp) is inserted in the groove of the rim.
- If not, position the bead pressing tool at 3 o'clock to press the bead into the rim grove.
- Restart the rotation to complete the mounting phase.
- Remove clamp, bead pressing tool, lever-less head and bead presser roller.
- Set the bead breaking unit to the rest position

9.7. TYRE INFLATION

9.7.a. SAFETY INDICATIONS
• RISK OF EXPLOSION
• Never exceed tyre pressure recommended by tyre manufacturer.
• Always match the tyre and rim dimensions.
• Take care to avoid any damage to the tyre.
• During inflation, keep outside the vertical cylinder area occupied
by the wheel.
User's manual
DANGER
EN
34c
45

Publicité

Table des Matières
loading

Table des Matières