Location And Function Of Parts; Front Panel - Sony RMO-S594 Mode D'emploi

Location and Function of Parts

Front Panel

1
POWER switch
Push the button to turn the power on and off.
The power is on when the button is in the
depressed position, and off when fully
protruding.
2
POWER indicator
The green lamp lights up when the power is
turned on.
3
BUSY indicator
As this disk is inserted and the drive becomes
ready for read/write operation, the BUSY
indicator turns green. The orange lamp lights
up when the disk unit is accessing or writing
data. This lamp flashes on and off at about 2-
second intervals when the unit overheats,
regardless of whether or not a disk is being
accessed.
4
Disk insertion slot
Insert the disk cartridge into this slot. Refer
to the section "Inserting a Disk Cartridge" on
page 13 for more information.
BUSY
POWER
1 2 3
Fig. 1-2: Front View
EJECT
4 5 6
5
Emergency eject hole
If the disk cartridge cannot be ejected using
the EJECT button 6 , turn off the power and
insert the supplied emergency eject tool into
this hole to trip the emergency eject
mechanism. Refer to the section "What to do
if the disk does not eject" on page 14 for
further details.
6
EJECT button
Press this button to eject the disk cartridge
from the disk unit. The EJECT button is
disabled with the function switch or software
settings prohibit ejection. When the write
cache is enabled, it may take a few moments
(up to 45 seconds) for the disk to eject
because data in the cache must first be
written to the disk.
7
Chapter 1 Introduction