Drain System - Amana NFW5800HW Instructions D'installation

Custom under-counter installation:
1"
(25 mm)
Recessed area or closet installation:
3"
(76 mm)
48 in.
2
(310 cm )
2
24 in.
2
3"
(155 cm )
2
(76 mm)
(5 mm)
Custom cabinet installation:
0.25" 1"
(5 mm) (25 mm)
4
39" min.
(991 mm)
1"
(25 mm)
27"
(686 mm)
1"
(25 mm)
1" 1"
0.25"
(25 mm) (25 mm)
1"
(25 mm)
1"
(25 mm) (25 mm)

DRAIN SYSTEM

The drain system can be installed using a floor drain, wall
standpipe, floor standpipe, or laundry tub. Select the method
you need.
IMPORTANT:
hose should be inside standpipe. Always secure drain hose with
cable tie.
Floor standpipe drain system
4.5"
(114 mm)
Minimum diameter for a standpipe drain: 2" (51 mm). Minimum
carry-away capacity: 17 gal. (64 L) per minute. A 1/4" (6 mm)
diameter to 1" (25 mm) diameter Standpipe Adapter Kit is
available (Part Number 3363920). Top of standpipe must be at
least 39" (991 mm) from the floor; install no higher than
96" (2.44 m) from bottom of washer. If you have an overhead
sewer and need to pump higher than 96" (2.44 m), a sump pump
and associated hardware are needed. See "Alternate parts."
Wall standpipe drain system
4.5"
(114 mm)
1"
(25 mm)
See requirements for floor standpipe drain system.
Laundry tub drain system
4.5"
(114 mm)
Minimum capacity: 20 gal. (76 L). Top of laundry tub must
be at least 39" (991 mm) from the floor; install no higher than
96" (2.44 m) from bottom of washer.
4.5"
(114 mm)
1"
To avoid siphoning, only 4.5" (114 mm) of drain
39"
(991 mm)
min.
"
39
(991 mm)
min
.
39
"
(991 mm)