Vermeiren V-drive Mode D'emploi page 5

3. V-Drive Installation
Feed the telescopic bar through the front end
of the V-drive. Loosen the tristar knob on the
bar and adjust to the correct length.
Tighten the knobs on the bar and at the front
of the V-drive. Place the two ends of the bar
on the rear of the brackets, then push the V-
drive forward until it locks in position.
4. Battery Pack Installation
Place the battery pack in to the battery tray as
shown in the photograph. Secure the battery
pack by pushing it all the way in. An audible
click will be heard.
5. Final Connection
Connect the cable from the V-drive in to the
underneath of the handset.
Place the top loop of the lift-up strap around
the opposite push handle to the handset.
DIS SSEMBLY ND TR NSPORT TION
1. Switch the V-Drive off at the ignition.
2. Disconnect / unclip the V-drive connector
from underneath the handset.
3. Remove the lift-up strap from the push han-
dle.
4. Lift the battery pack out of the battery tray.
5. Remove the batterypack out of the tray by
pulling at the handle of the battery pack and
simultaneously pushing the PUSH button at the
bottom of the batterypack.
6. Place all items in the carry holdall supplied.
Notes: The battery supplied with the V-Drive
is classified as safe for air travel by compli-
ance with IATA special provision A67. The
battery pack and V-drive have fabric handles
to make them easier to carry.
GB