Pollet Water Pallas Condor Mini Manuel D'installation page 14

. By-passing
e system is equipped with a bypass and if a problem occurs, turn the valves to bypass the system as shown in the picture
w.
Normal
operation
In
. Programming
6.2. BASIC PROGRAMMING
Note:
The controller must be plugged to be programmed.
Caution: The programming has to be
After 5 minutes without any button pressed, the unit returns to normal operation without saving.
done only by the installer for the setting
1. Basic programming
In of the valve parameters. The modification
Note:
Menus are displayed in a defined and incremental order.
of one of these parameters could prevent
the good functioning of the device.
ay of Override
Note:
Determine the maximum number of days of operation without regeneration. To enter the programming mode, the
Programming
valve has to be in service. While in
Note:
egeneration time
The controller must be plugged to be programmed.
program mode, the valve will continue
After 5 minutes without any button pressed, the unit returns to normal operation without saving.
Press and simultaneously for 5 seconds to enter the menus sequence.
to operate normally monitoring all
Select the number of days of Override with
. Basic programming
information. The programming is
Press to validate the selection and advance to the next parameter.
Note:
Menus are displayed in a defined and incremental order.
stored in permanent memory with or
Note:
Determine the time of regeneration.
of Override without line or battery backup power.
Note:
Determine the maximum number of days of operation without regeneration.
Adjust the regeneration time with
To enter the programming mode,
Press to validate the selection and advance to the next parameter.
eneration time
press simultaneously
Press and simultaneously for 5 seconds to enter the menus sequence.
for 5 seconds.
Select the number of days of Override with
Press on the button
Press to validate the selection and advance to the next parameter.
36
Note: jump to the next stage. Use the
Determine the time of regeneration.
and
Adjust the regeneration time with
the displayed values.
Press to validate the selection and advance to the next parameter.
Note: You must pass through all
the programming steps and come
back in service position to save the
modifications that have been done
6
during the programming mode.
Join our mission.
Make water count.
14
Softening
System
Out
Out
and
and .
and
and
in order to
buttons in order to modify
and .
In Bypass
Softening
System
In
After 5 minutes without any button
pressed, the unit returns to normal
operation without saving.
In
6.2.1 Day of override - DO
Determine the maximum number
of days of operation without
regeneration
• Press
simultaneously
.
for 5 seconds to
enter the menus sequence.
• Select the number of days of
Override with
• Press
and advance to the next parameter.
.
6.2.2 Regeneration time - RT
• Adjust the
regeneration
time with
and
• Press
and advance to the next parameter.
Out
Out
and
and
to validate the selection
Ref. MKT-UG-008 / C - 14.11.2019
to validate the selection
Ref. MKT-UG-008 / C - 14.11.2019