Installation - Pollet Water Pallas Condor Mini Manuel D'installation

5. INSTALLATION

5.1. PREPARATION OF
THE INSTALLATION
Location
The device is only to be used for
interior operation.
Install your softener on a flat, firm and
clean surface.
The unit must be close to a drain line
to allow an easy connection.
The electrical connexion must be done
in accordance to the local legislation.
It is essential to foresee sufficient
space for installation, commissioning
and easy maintenance. It is also
important to ensure a good access for
filling salt.
Pressure
A minimum incoming pressure of
1,8 bar (30psi) is needed to allow
the valve to perform a proper
regeneration.
If the water pressure is higher than
8.0 bar (120psi), use a pressure
reducer upstream of your installation.
If there is a risk of sudden pressure
surge, a pressure reducer is also to
be installed.
Join our mission.
Make water count.
10
Power connection
Be sure that the power cannot be
switched off accidentally by a wall
switch.
If the power cable is damaged, please
ask a skilled electrician to change it.
When the unit is disconnected from
the electrical network for a number of
days, do not forget to reprogram the
clock.
When the unit stays disconnected
from the electrical network for a long
period of time, please verify if all
parameters are still set at the correct
values.
Plumbing
The plumbing must be in good state.
In case of doubt, please change it.
All plumbing for the water inlet,
distribution and drain line should be
done correctly and in accordance
with the legislation in force at the time
of the installation.
Possible soldering should be done
before installing the softener. Failing
to do so can generate irreversible
damages. For any operation, shut
down water inlet, unplug your