Pollet Water Pallas Condor Mini Manuel D'installation page 12

5.2. PHYSICAL INSTALLATION
After unpacking the system, please
put the power supply, bypass valve
and any other accessories apart.
When moving the system, pay
attention not to hold or move the
softener by hoses, valves or other
parts not suited for that purpose.
In cold weather, it is recommended
Installation of the bypass on the softener:
• The installation of a bypass allows you
to bypass the water softener when
required (maintenance, need
for unsoftened water, ...).
• Use the clips to fix the bypass to the
income and the outlet of the Valve.
• The drain connection on the valve
must be connected to the drain.
• The overflow connection on the
cabinet has to be connected to
a drain that is situated below the
softener as possible water coming out
is unpressurised.
• Fill the salt reservoir with 50mm water.
Do not add salt for the moment.
• Put the by-pass valve of your Pallas
Condor in the "by-pass" position.
Open the raw water feed tap and a
cold water tap for a few minutes until
Join our mission.
Make water count.
12
that the Pallas Condor is brought
up to ambient temperature before
proceeding with the installation.
The Pallas Condor must be positioned
so that it is protected from freezing
temperatures. Do not install the unit
where it is exposed to direct sunlight
or high temperatures (45 °C max).
all of the pipes are rinsed of any
residual foreign bodies (solder re-
mains). Turn off the raw water feed tap
and cold tap when water runs clear.
NORMAL OPERATION
Softening system
IN OUT
Connect the softener electrically.
IN BYPASS
Softening system
IN OUT