Checking The Floor Where The Appliance Will Be Placed; Preparing The Place Of Installation; General Considerations; Safety Precautions - Royal ECOFIRE LEA US 90 Notice D'installation Et D'entretien

During lifting, avoid jerking or abrupt movements.
Pay attention to overbalancing.
5.2 Checking the floor where the
appliance will be placed
Check the load capacity of the floor slab.
In the case of a floor that is not suitable to
support the weight of the appliance, install
suitable steel plates (A - Fig. 10) or concrete base
(A - Fig. 11) equipped with electrowelded mesh
10x10x6 (B - Fig. 11) to distribute the weight.
For the dimensions of the plates and
the concrete base, use a qualified
technician.
A
A
B
004776771 - 29/10/2021
ITALIANO ENGLISH
10 mm
Fig. 10
Fig. 11
DEUTSCH
6 PREPARING THE PLACE
OF INSTALLATION
6.1

General considerations

The following paragraphs contain some guide-
lines to be followed to obtain the maximum
efficiency of the product purchased and to
ensure safe operation. The following indications
are however subject to compliance with any
possible national, regional and municipal laws
and regulations in force in the country where the
appliance is installed.
In Italy, installation must be performed by quali-
fied personnel in compliance with the EN 10683
standard.

6.2 Safety Precautions

The operations for assembly and disassembly of
the appliance are reserved for specialist techni-
cians only.
It is recommended to be sure of their qualifica-
tions and their actual capacity.
For Italy, these technicians must be in
possession of the letter "C" qualification
issued by the chamber of commerce
based on the Ministerial Decree. 37/08.
FRANÇAIS ESPAÑOL
57