Thermo Scientific S1 Pipet Filler Guide D'utilisation page 8

Wall Attachment
The enclosed S1 Pipet Filler
wall mount may be attached to
a smooth, clean surface using
the adhesive backing (also
included). For best results,
wipe the wall surface with
alcohol, let dry, press wall
mount fi rmly in place and
allow to set overnight before
using. For rough surfaces,
mount with screws.
1mL Pipet Support
To enhance pipetting
performance when using 1mL
pipets, S1 Pipet Filler features
a unique pipet support. Simply
snap the accessory into the
nosecone housing, insert your
pipet, and perform your chosen
application with a stable,
wobble-free pipet.
Power Requirements
Power supply input
Power supply output
Environmental Operating Conditions
For optimum performance, your S1 Pipet Filler
should be used under the following range of
conditions:
Operating altitude
Operating temperature
Storage temperature
Relative humidity
Mains supply voltage fl uctuations
(for external power supply) 90V AC or 264V AC
Transient overvoltage
(for the power supply)
Applicable rated
pollution degree
8
100V AC or 240V AC,
50-60 Hz, 0.2 - 0.6 A
6.0V DC, 0.5 - 0.6 A,
Constant Current
0-1,524m
10-35°C (For Indoor Use Only)
-10 to 40 ° C
10-95% non-condensing
Installation Category II
Pollution Degree 2 (normally
only non-conductive pollution
occurs)