Output Of Negative Image - JVC 3-CCD KY-F550 Mode D'emploi

Output of Negative Image

It is possible to convert video signals from the various output terminals of this unit into negative images.
[MENU] [5] [SET]
5 / BARS
1 2 3 4
MENU SET
∞/ AW
[∞] Switch 4: [OFF]
2. 3.
- - - SYSTEM - - -
NEGA T I VE OF F
P I XE L COM PEN CANCE L
DV SYSTEM JVC
PAGE BACK
"SYSTEM" Screen
4. 5.
- - - SYSTEM - - -
NEGA T I VE ON
P XE L COM I PEN CANCE L
DV SYSTEM JVC
PAGE BACK
"SYSTEM" Screen
1.
2.
3.
Blinking
4.
5.
Make sure that the Switch 4 located at the side of this unit is
set to [OFF] (lower side).
Press the [MENU] button for 1-2 seconds.
The "MENU" screen will be displayed.
Use the [5/∞] buttons to select "SYSTEM..", then press the
[SET] button.
The "SYSTEM" screen will be displayed.
Use the [5/∞] buttons to select "NEGATIVE", then press the
[SET] button.
The set value starts blinking and adjustment is possible.
Use the [5/∞] buttons to set value to "ON", then press the
[SET] button.
This will be recorded in the memory of this unit.
Output image will be converted to negative images.
Press the [MENU] button for 1-2 seconds.
The normal screen will be displayed.
E-27