System" Screen - JVC 3-CCD KY-F550 Mode D'emploi

"PROCESS (2/2)" Screen (continued)
Settings in bold are factory settings
Item
"FLARE (R)"
"FLARE (B)"
"PAGE BACK"

"SYSTEM" Screen

Settings in bold are factory settings
Item
"NEGATIVE"
"PIXEL
COMPEN"
"DV SYSTEM"
"PAGE BACK"
For correcting Rch of black level in accordance with the luminance level when
light that enters the lens reflects irregularly, hence causing flare, where colour
appears on the black portion. Perform this together with "FLARE (B)".
Increase value : Increases the black level of Rch to enhance the reddishness.
Decrease value : Decreases the black level of Rch to reduce the reddishness.
{Variable Values : –10 - 0 - +10}
For correcting Bch of black level in accordance with the luminance level when
light that enters the lens reflects irregularly, hence causing flare, where colour
appears on the black portion. Perform this together with "FLARE (R)".
Increase value : Increases the black level of Bch to enhance the bluishness.
Decrease value : Decreases the black level of Bch to reduce the bluishness.
{Variable Values : –10 - 0 - +10}
Press the [SET] button to return to the "PROCESS(1/2)" screen when cursor is at
this position.
Signals from the various output terminals can be output as negative signals.
"ON" : Outputs negative signals.
"OFF" : Outputs normal video signals.
For setting whether to perform white spot correction.
"CANCEL" : Do not perform white spot correction.
"EXECUTE" : Perform white spot correction.
☞ Page 28 'White Spot Correction'
For setting the software to be used for remote-controlling this unit via the [DV]
terminal.
"JVC" : When using the exclusive software of this unit.
"OTHERS" : When using software other than the exclusive software.
(Setting of '9 Function Setting Switch' on the side of this unit is necessary
☞ Page 10)
Press the [SET] button to return to the "MENU" screen when cursor is at this
position.
Function/Variable Values
Function/Variable Values
E-41