Publicité
Les langues disponibles
Les langues disponibles
ENGLISH
16
Mains Connection
Operation is only allowed with a safety switch
against stray current (RCD max. stray current of
30mA).
Before putting into operation, a qualified electrician
must check whether electric safety measures required
are in place. Any national regulations in this regard
must be complied with.
Electric connection to a socket.
It is necessary to make sure the connecting socket
was not near water and humidity and the plug was
protected against humidity.
Check the voltage. Technical data given on the type
label must correspond with electric network voltage.
Only use splash proof extension cables approved for
outdoor purposes.
Check the cable and/or socket for damages before
the appliance putting into operation.
Never use the charger when the cable, plug or the
machine is damaged by external influences. In case
damage let repaired in authorized workshop
To avoid danger, a damaged mains supply pipe must
be replaced by the manufacturer. Do not under any
circumstances attempt any repair yourself.
Cable connections to be separated by pulling the
plug only. Pulling the cable could damage both the
cable and plug. As a result, electric safety would no
longer be guaranteed.
Over-temperature protection
The power will automatically be reduced should the
apparatus heat up too much during charging. This will
protect the apparatus.
Symbols
WARNING/Caution!
Warning against dangerous electric
voltage
Read the operating instructions to reduce
the risk of injury.
Wear eye protective goggles !
Wear gloves!
Unplug the machine before any work
on it.
Charger to be used in closed spaces only.
~
AC Current
Plus – positive terminal
Minus – negative terminal
This equipment is in safety class II.
Direct Current
CE marking
Any damaged or disposed electric or
electronic devices must be delivered to
appropriate collection centres.
Publicité
