Gima KD-595 Manuel De L'utilisateur page 25

25
with IEC 60601-1/En 60601-1/UL 60601-1 and IEC 60601-1-2/En
60601-1-2/UL 60601-1-2 is suitable for this monitor. please note that
the monitor jack size: hole Ø 5.5mm, center pin Ø 2.0mm.
please pay attention to polarity.
16. this equipment has been tested and found to comply with the limits
for a Class b digital device, pursuant to part 15 of the fCC rules.
these limits are designed to provide reasonable protection against
harmful interference in a residential installation. this equipment
generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on,
the user is encouraged to try to correct the interference by one or more
of the following measures:
- reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from
that to which the receiver is connected.
- Consult the dealer or an experienced radio/tV technician for help.
17. this blood pressure monitor is verified by auscultatory method.
It is recommended that you check annex b of anSI/aamI
Sp-10:2002+a1:2003+a2:2006 for details of verification method
if you need.
ENGLISH