Sony UP-DP10 Mode D'emploi page 32

Miscellaneous
Symptom Cause/Remedy
Paper • Check whether you have loaded
jams more than 25 sheets of paper in the
paper supply/eject tray.
t Load no more than 25
sheets of paper in the paper
supply/eject tray at a time.
• Check whether more than 10
sheets of paper have accumulated
on the eject surface of the paper
supply/eject tray.
t Do not allow more than 10
sheets of paper to
accumulate on the eject
surface.
• Check whether the paper is
wrinkled or curled.
t Remove any wrinkled or
curled paper.
The • Check whether paper has jammed.
ALARM t Clear the jam as explained
lamp is lit in "If the Paper Jams"
(page 33).
• Check whether the ink ribbon has
broken.
t Correct the problem as
explained in "If the Ink
Ribbon Breaks" (page 34).
The • Check whether you are printing on
printed the right side of the paper.
result t Properly load the printing
does not paper as explained in
look "Loading the Printing Paper"
clean. (page 17)
• Check whether the ink ribbon
cartridge or printing paper are dirty.
t Load a new ink ribbon
cartridge or clean printing
paper.
32
Status Indications
The printer status is indicated by the POWER,
PRINT, PAPER, RIBBON, and ALARM lamps
lighting or flashing. If the printer is in an
abnormal condition, take whatever action is
called for by the status indicated by the lamps.
Lamp Lit Flashing Printer status and action
a • The power is on.
POWER
a • Printing is in progress.
PRINT
a • The printer is receiving
image data.
a • The printer is out of paper.
PAPER
• There is too much
accumulated ejected paper
in the paper supply/eject
tray.
• The printer cannot use the
type of paper that has been
loaded.
a • The end of the ink ribbon
RIBBON
has been reached.
• No ink ribbon cartridge has
been installed.
• The ink ribbon cartridge that
has been installed is not
compatible with this printer.
t Load more paper in
the paper supply/
eject tray. (page 17)
t Remove the
accumulated ejected
paper from the paper
supply/eject tray.
t Once the paper has
been ejected, load
the correct type of
paper in the paper
supply/eject tray.
(pages 14, 17)
t Install a new ink
ribbon cartridge.
(pages 16, 19)
t Install an ink ribbon
cartridge. (page 16)
t Install the correct ink
ribbon cartridge.
(pages 14, 16)