Sony UP-DP10 Mode D'emploi page 18

Preparing to Print
18
Notes
• Do not place more than 25 sheets in the tray at one time.
• When loading printing paper in the tray, make sure that all of the paper
is completely inside of the tray.
• Do not use paper that is significantly curled.
• When outputting multiple sheets of paper to the eject surface of the
paper supply/eject tray, raise the stopper.
3
Open the paper supply/eject tray cover.
4
Align the protuberances on the tray with the grooves in the printer, slide
the tray in as far as it will go, and then make sure that the PAPER lamp
has turned off.
Notes
• Do not allow more than 10 sheets of paper to accumulate on the eject
surface of the paper supply/eject tray.
• To prevent dust contamination, attach the provided tray cover to the
paper supply/eject tray when you take the tray out of the printer.
The printer is now ready to print. To print, first read "Preparing to Print"
(page 14). Once printer setup is complete, use the Print function in any
typical application software to print.
Stopper