Troubleshooting - Zanussi ZGO63414 Notice D'utilisation

Removing the dirt:
1. – Remove immediately: melting plastic,
plastic foil, and food containing sugar.
– Stop the appliance and let it cool
down before you clean: limescale rings,
water rings, fat stains, shiny metallic dis-
colorations. Use a special cleaner appli-
cable for surface of hob.
2. Clean the appliance with a damp cloth and
some detergent.
3. At the end rub the appliance dry with a
clean cloth.
Warning! Do not use knives, scrapers or
similar instruments to clean the surface of
the glass or between the rims of the burners
and the frame (if applicable).

Troubleshooting

Problem
There is no spark when lighting
the gas
The flame is blow out immediately
after ignition
The gas ring burns unevenly
If there is a fault, first try to find a solution to the
problem yourself. If you cannot find a solution to
the problem yourself, speak your dealer or the
local Service Force Centre.
If you operated the appliance incorrectly,
or the installation was not carried out by a
registered engineer, the visit from the customer
service technician or dealer may not take place
free of charge, even during the warranty period.
www.zanussi.com
Also, do not let hard or sharp objects fall onto
the glass or hit the edge of the hob.
Cleaning of the spark plug
This feature is obtained through a ceramic igni-
tion candle with a metal electrode. Keep these
components well clean to prevent difficult light-
ing and check that the burner crown holes are
not obstructed.
Periodic maintenance
Periodically speak your local Service Force
Centre to check the conditions of the gas sup-
ply pipe and the pressure adjuster, if fitted.
Possible cause
• There is no electrical supply
• Burner cap and crown are
placed uneven
• Thermocouple is not heated
sufficient
• Burner crown is blocked with
food residues
These data are necessary to help you
quickly and correctly. These data are
available on the supplied rating plate.
• Model description .................
• Product number (PNC) .................
• Serial Number (S.N.) .................
Use the original spare parts only. They are
available at Service Force Centre and approved
spare parts shops.
Warning! Do not slide cookware over the
glass because it could scratch the surface.
• Make sure that the unit is con-
nected and the electrical supply
is switched on.
• Control the fuse. If the fuse is
released more than one time,
refer to a qualified electrician.
• Make sure that the burner cap
and crown are in correct posi-
tions.
• After lightning the flame, keep
the knob pushed for approxi-
mately 5 seconds.
• Make sure that the injector is
not blocked and the burner
crown is clear of food particles.
Remedy
21