Warning! Be very careful when you use
open fire in kitchen environment.
Manufacturer decline any responsibility in case
misuse of the flame
Always light the burner before you put
cookware.
To light the burner:
1. Turn the control knob counterclockwise to
the maximum position (
down.
2. Keep the control knob pushed for approxi-
mately 5 seconds; this will let thermocou-
ple to warm up. If not, the gas supply will
be interrupted.
3. Adjust the flame after it is regular.
If after some tries the burner does not
light, check if the crown and its cap are in
correct positions.
A) Burner cap and crown
B) Thermocouple
C) Ignition candle
Helpful hints and tips
Warning! Refer to the Safety chapters.
Energy savings
• If possible, always put the lids on the pans.
www.zanussi.com
If the burner does not light after 15 seconds,
release the control knob, turn it into off position
and try to light the burner again after minimum
1 minute.
Important! In the absence of electricity you
can ignite the burner without electrical device;
in this case approach the burner with a flame,
) and push it
push the relevant knob down and turn it
counter-clockwise to maximum gas release
position.
light the burner again after minimum 1 minute.
stallation or a power cut. It is normal.
Turning the burner off
To put the flame out, turn the knob to the sym-
A
bol
from the burner.
B
C
• When the liquid starts to boil, turn down the
flame to barely simmer the liquid.
Use cookware with diameters applicable to the
size of burners.
Warning! Do not keep the control knob
pushed for more than 15 seconds.
If the burner accidentally goes out, turn the
control knob to the off position and try to
The spark generator can start automatical-
ly when you switch on the mains, after in-
.
Warning! Always turn the flame down or
switch it off before you remove the pans
19