Installation - Zanussi ZGO63414 Notice D'utilisation

Labels supplied with the accessories bag
Stick the adhesive labels as indicated below:
1
MOD.
PROD.NO.
SER.NO
DATA
MODEL
Stick it on Guarantee Card and send this
1
part
Stick it on Guarantee Card and keep this
2
part

Installation

Warning! Refer to the Safety chapters.
Warning! The following instructions about
installation, connection and maintenance
must be carried out by qualified personnel in
compliance with standards and local
regulations in force.
Gas Connection
It is necessary that the connection to the gas
mains are carried out by means of an AGB tap.
Choose fixed connections or use a flexible pipe
in AGB (stainless steel) in compliance with the
regulation in force. If you use flexible metallic
pipes, be careful they do not come in touch
with mobile parts or they are not squeezed. Al-
so be careful when the hob is put together with
an oven.
The connection must be done according to
regulation NBN D 5I.003.
Important! Make sure that the gas supply
pressure of the appliance obeys the
22
2
MOD.
PROD.NO.
SER.NO
03 IT
DATA
MADE IN ITALY
MODEL
3
MOD.
PROD.NO.
0049 SER.NO.
Stick it on instruction booklet
3
recommended values. The adjustable
connection is fixed to the comprehensive ramp
by means of a threaded nut G 1/2". All the
components shown in the figure have already
been assembled in the factory. The appliance,
before leaving the factory, has been tested in
order to give you the best results.
A
A) End of shaft with nut
B) Washer
C) Elbow
Liquid gas: use the rubber pipe holder. Always
engage the gasket. Then continue with the gas
TYPE
230V-50Hz
IP20
B C
www.zanussi.com