Publicité
INSTRUCTION FOR USE
SAFETY INSTRUCTIONS
1. Please keep this instruction sheet safely for future reference.
2. Please do not modify the product or the assembly details in any way. Modifi cations will aff ect the structural
integrity and replacement parts will be at the buyer's expense. Inappropriate use or faulty application of the
product are explicitly forbidden and absolve the manufacturer of all liability.
3. The use of the item is allowed only under continuous supervision by an adult.
4. This product meets all security aspects of the European standards EN1176-1:2017. This product is fi t for
outdoor and indoor commercial playgrounds.
5. The application of the item as part of a playframe or any other construction will have to be such that it ex-
cludes all risks of entrapment.
6. When mounting or assembling the device, attention should be given to the minimum required distance
between the device and eventual obstacles (impact area). Dimension of the impact area depends on the free
height of fall (FIG I). The impact area shall be at least 1,5 m around the equipment, measured horizontally.
In this safety area no hard, angular or pointed objects should be present (FIG II).
7. The safety surface underneath the product must be flat, and be covered in a suitable way and meet the re-
quirements of EN1176-1:2017. The product must not be placed on asphalt, concrete or any other hard
surface.
8. Connections shall be safeguarded so that they cannot be undone without tools (e.g. with glued threaded
joints).
9. No spare parts are provided with the device. In case of a damage, spare parts can be purchased from the
manufacturer.
INSPECTION AND MAINTENANCE
The frequency of inspection and maintenance will vary depending on type of equipment, impact attenuating
surfacing, materials used and other factors (e.g. heavy use, levels of vandalism, coastal location, air pollution,
age of equipment, whether the stability of the equipment relies on one pole...). The frequency of inspection
should be increased if there are factors that reduce the impact attenuation level over time (e.g. degradation of
organic materials, ageing due to UV exposure).
Routine visual inspection (weekly to monthly)
- Always check that the bolts and nuts are securely fastened.
- Check the shock absorbing surface for objects that don't belong there.
- Check for missing parts.
- Check the surface for dangerous objects that don't belong there.
Operational inspection (1 to 3 months)
- Check the stability of the construction.
- Check every part for excessive wear and replace when necessary.
Annual inspection (1 to 2 times per year)
- Check for rust and corrosion.
- Check every part for excessive wear and replace when necessary.
2
HANDPAN 'duet' with mallets
EN
FIG II
ASSEMBLY - MONTAGE - MONTAJE - MONTAGGIO - MONTAŻ
ASSEMBLY - MONTAGE - MONTAJE
MONTAGGIO - MONTAŻ
Instructions for use - M560.010 - HANDPAN 'duet' with mallets
min. 150 cm
35
Publicité
