Locomotive Characteristics; Information About Operating The Train; Trouble Running The Train - marklin 29074 Notice D'utilisation

When this process has been completed suc-
cessfully, the locomotive will be stored in the first
available space with its name, functions, and its
symbol.
Now the locomotive is ready to be run.
7.1 Controlling the Locomotive
The locomotive is accelerated by turning the speed
control knob. Turning the knob in the opposite
direction will slow the locomotive.
The direction is reversed by pressing on the speed
control knob when the locomotive is stopped.
An emergency stop is done by pressing the button
„Stop". When you press the button next to a func-
tion symbol, this function is turned on or off.
Note: When a new locomotive is selected and the
Mobile Station is set for a speed position (it does
not matter which one), the locomotive just selected
will run at that speed that was last set. This loco-
motive cannot be controlled again until it has been
selected again.
You will find a complete description of the possibi-
lities and the operation of the Mobile Station in the
instruction manual included with this device.

8. Locomotive Characteristics

• Recognition of the mode of operation: automa-
tic.
• Mfx technology for the Mobile Station / Central
Station. Name set at the factory: BR 74 854
• This locomotive is set for the address 78 for
operation with other control devices.
• Various controllable functions.
• Setting the locomotive parameters (address,
acceleration/braking delay (ABV), maximum
speed): with the Control Unit, Mobile Station,
Central Station.
• Headlights, changing over with the direction of
travel.
• Only the train control functions and headlight
changeover feature are available in analog ope-
ration.
8.1 Function Switch
The Mobile Station can activate 32 digital func-
tions on the locomotives.
Controllable Functions
Headlights, on/off
ABV, off/on

9. Information about Operating the Train

Running 2 Trains
!
Only one switched mode power pack and one
digital connector box may be used with this
layout.
The switched mode power pack included with
the starter set provides power sufficient for a
maximum of 2 trains.
The locomotive to be controlled can be selected
with the Mobile Station.

10. Trouble Running the Train

• If the train does not run, check to make sure
that the connections have been done as shown
in Section 6.
• Check to see if there a short circuit or an
overload on the layout or if a locomotive or
car is derailed. Correct the short circuit or the
overload by reducing the number of power
consumers (locomotives, lighted cars, etc.), and
set the derailed locomotive or car back on the
rails.
• Remove damaged cars and locomotive from the
train and have them repaired. Defective cars
and a defective locomotive must not be used
f0 - f3 f4 - f7
Funktion 0
Funktion 4
11