Publicité
Les langues disponibles
Les langues disponibles
• If you want to use only one drill bit in
your Dowel Machine, remove both the
drill bit and retaining grub screw fully as
the grub screw could come out at high
speed and could be dangerous to yourself
or a bystander.
• Only use drill bits with a diameter from
6mm to 10mm.
• Use this tool only for drilling into timber
and wood products such as particle board.
• Ensure that you have removed foreign
objects such as nails and screws from the
work before commencing work.
• Rags, cloths, cord, string and the like
should never be left around the work area.
• Use safety equipment including safety
goggles or shield, ear protection, dust
mask and protective clothing including
safety gloves.
Wear goggles, Wear earmuffs,
Wear a breathing mask
GB
6
General Safety Instructions
EXTENSION CORDS
• Replace damaged cords immediately.
Use of damaged cords can shock, burn
or electrocute.
• If an extension cord is necessary, a cord
with adequate size conductors should be
used to prevent excessive voltage drop,
loss of power or overheating. The table
shows the correct size to use, depending
on cord length and nameplate amperage
rating of tool. If in doubt, use the next
heavier gauge. Always use U.L. and CSA
listed extension cords.
RECOMMENDED SIZES OF
EXTENSION CORDS
Tool's
Volts Total length of cord in feet
Ampere
Cord size in
rating
A.W.G.(minimum)
25ft
50ft
100ft
150ft
3–6
120V~
18
16
16
14
6–8
120V~
18
16
14
12
8–10
120V~
18
16
14
12
10–12
120V~
16
16
14
12
12–16
120V~
14
12
-
-
SYMBOLS
ENVIRONMENTAL PROTECTION
Waste electrical products should not
be disposed of with household waste.
Please recycle where facilities exist. Check
with your local authority or retailer for
recycling advice.
Always wear ear, eye and
respiratory protection.
Double insulated for
additional protection.
Instruction warning.
Instruction note.
GB
Symbols
7
Publicité
