Publicité
Les langues disponibles
Les langues disponibles
User Manual
Overview & Operation
Front Panel
POWER MENU
1
1.
IR Window
Receives IR commands from the supplied IR Remote
2.
Power
Switch the Matrix On/Off
3.
Menu
Press to launch the OSD menu
Press to make a menu selection in the OSD
Press along with "-" to set the Output to 720p@60Hz
Press along with "+" to set the Output to 1024x768@60Hz
4.
-/+ Buttons
Use these buttons to move up and down in the OSD
Channel Input (1 – 4) / Channel Output (A – D) Selection
5.
In Matrix Mode select an Output by pressing one of the buttons marked A – D, then select the Input
to be used by pressing one of the buttons marked 1 – 4. Repeat this for each Output. Each Output
can independently display any of the Inputs according to your selection.
In Dual Mode there are two groups, Dual A (Outputs A & B) and Dual B (Outputs C & D). To set up
Dual A select Output A then select the first input by pressing one of the buttons marked 1 – 4. Now
select Output B then select the second input by pressing one of the buttons marked 1 – 4, without
duplicating your initial selection. Your two input selections will now be shown on Output A and Output
B. For Dual B repeat this for Output C and D as required. Press and hold Output A or B for 3 seconds
to select the audio input for Dual A, or Output C or D to select the audio input for Dual B.
In Video Wall Mode select the input to be displayed across the 4 displays (2x2 configuration) by
selecting Input 1 – 4. Audio will be available through Output A only.
6.
Matrix / Dual / Wall Mode
Press this button to switch between the different modes. When Matrix Mode is selected the button will
stay constantly illuminated, for Dual Mode the button will not illuminate and for Video Wall Mode the
button will blink on/off.
7.
Lock
Press this button once to lock the keypad and remote control, press and hold the button again for 3
seconds to release the lock.
8.
Save
Once you have configured the Matrix (Mode selection, Input/Output combinations etc.) press the Save
button, the Input 1 – 4 buttons will then illuminate. Now press one of the Input buttons to save your
configuration. Pressing Input 1 would save the configuration to slot 1, this can then be recalled using
the Recall button (see below) or by pressing Fav.1 on the IR Remote.
9.
Recall
Press the Recall button, the Input 1 – 4 buttons will then illuminate. Now select which saved
configuration you want to recall by pressing Input button 1/2/3/4.
720P
-
+
XGA
2
3
4
OUTPUT
A
B
C
D
INPUT
1
2
3
4
5
6
7
MATRIX/
DUAL/WALL
LOCK
SAVE
RECALL
8
9
English
Publicité
