Ej Report Reading And Resetting - Sharp XE-A113 Manuel D'instructions

EJ REPORT READING AND RESETTING

The cash register provides an electronic journal (EJ) function. This function is intended to record the journal
data in a memory instead of journal paper, and print the data as an EJ report. The register records the journal
data in REG, PGM,
memory. For details of EJ programming, please refer to "Other programming (Job code 68) on page 58 and
(Job code 70) on page 60".
Printing journal data on the way of a transaction
You can print journal data of a current transaction recorded in EJ memory by pressing the
transaction.
This function is valid when the printing style is programmed to receipt, and the receipt ON/OFF function
is set to OFF. For changing the setting, refer to "Additional Information for BASIC SALES ENTRY".
• Sample print
Reading and resetting the electronic journal data (Issuing EJ report)
You can read the journal data stored in the EJ memory in the journal format by executing the following
procedure in the X1/Z1 or OP X/Z mode.
To read all of the data:
7:
To reset all of the data:
7:
To read the last 10 records:
710
• By programming, you can also issue an EJ Z report without
printing the journal data on it. Refer to "Other programming (Job
code 70)" on page 60 for the programming.
• To stop reading or resetting the data, turn the mode switch to
"MGR" position. The data will not be erased when resetting.
• On the EJ memory, a maximum of 3000 lines of data can be
stored. When executing all data reading, all of the data stored
in the EJ memory will be printed.
• When printing is performed continuously, the printing may be
intermitted several seconds. After the intermission, the printing
will be restarted.
70
, X1/Z1 and X2/Z2 modes. By default, a maximum of 3000 lines are stored in the
EJ report title
EJ report end title
@ A
P @
@ A
• Sample EJ report
A
R
key during the
Header
information
print