Error Code Table - Sharp XE-A113 Manuel D'instructions

8 BEFORE CALLING FOR SERVICE
STEP
The malfunctions shown in the left-hand column below, labelled "Fault," do not necessarily indicate functional
faults of the machine. It is therefore advisable to refer to "Checking" shown in the right-hand column before
calling for service.
(1) The display shows symbols that do not make sense.
(2) The display won't illuminate even when the mode switch
is turned to any other position than "
(3) The display is illuminated, but the whole machine
refuses registrations.
(4) No receipt is issued.
(5) No journal paper is taken up.
(6) Printing is unusual.
(7) Continuous printing stops.

Error code table

When the following error codes are displayed, press the
below.
Error
code
E01 Registration error
E02 Misoperation error
E03 Undefined code is entered.
E07 Memory is full (in the
E11 Compulsory depression of the
direct finalization
E12 Compulsory tendering
E32 No entry of a clerk code
E34 Overflow limitation error
E35 The open price entry is inhibited.
E36 The preset price entry is inhibited.
E37 The direct finalization is inhibited.
E67 Subtotal void is not allowed.
Fault
".
Error status
a
key programming).
s
key for
1
QUICK START GUIDE
Part
Checking
• Has the machine been initialized properly as shown in
"PREPARING THE CASH REGISTER" on page 8?
(Note that initialization clears all the data and programmed
settings stored in memory.)
• Is power supplied to the electrical outlet?
• Is the power cord plug out or loosely connected to the
AC outlet?
• Is a clerk code assigned to the register?
• Is the mode switch set properly at the "REG" position?
• Is the paper roll properly installed?
• Is there a paper jam?
• Is the receipt function in the "OFF" status?
• Is the print roller arm securely locked?
• Is the take-up spool installed on the bearing properly?
• Is there a paper jam?
• Is the print roller arm securely locked?
Open the print roller arm, and lock the arm by following
the instruction of installation.
• Is the paper roll properly installed?
• Are the print head/sensor/roller clean?
• Display shows "– – – – –".
Printing will automatically restart after several seconds.
l
key and take a proper action according to the table
Make a correct key entry.
Make a correct key entry.
Enter a correct code
a
Program the key within 25 steps.
s
Press the key and continue the operation.
Make a tendering operation.
Make a clerk code entry.
Make a registration within a limit of entry.
Make a preset price entry.
Make an open price entry.
Make a tendering operation.
Finalize the transaction, and correct the wrong entries in the
mode.
2
Part
Action
3
Part
31