Periodic Inspection And Maintenance - Marmitek TLV 9600 Notice D'utilisation

SYMPTOM
Alarm
recording.
Noise in the
playback picture.
The date and
time are not
recorded.
The cassette tape
cannot be ejected
• Press the RESET button for
more than 5 seconds to perform
the reset. Running Time will not
be reset.
POSSIBLE CAUSE
"NO" is selected for alarm
recording in the ALARM REC SET
menu.
The tracking must be adjusted.
The video heads need cleaning.
"NO" is selected for the date and
time in the DISPLAY SET menu.
The date and time go off the ON-
SCREEN by pressing the DISPLAY
button.
Problem with the system or tape.

Periodic Inspection and Maintenance

Periodic inspection and maintenance should be referred to your
dealer. If there is noise in the playback picture, and it cannot be
corrected using the tracking control, it may indicated that the
video heads need cleaning. The video heads should be cleaned and
inspected every 1,000 hours. The video heads usage can be checked
using initial menu, running time.
System Down
If the unit does not function at all, try the following.
1 Unplug the power cord then plug it back in.
2 Reset the memory. (Press the RESET button. Under normal
conditions, do not touch the RESET button)
3 If the problem is not corrected after performing steps 1 and 2,
consult your dealer.
CORRECTIVE ACTION
- Be sure to select "YES" for alarm
recording.
- Adjust it by using the manual
tracking.
- Press the PLAY button in the
playback mode.
- Clean the video heads.
- Be sure to select "YES" for the
display.
- Press the DISPLAY button to
show the date and time.
- Unplug the power cord then plug
it back in.
36