Marmitek TLV 9600 Notice D'utilisation page 24

To Cancel a Program Timer Recording
1 Repeat step 1 of changing a program timer recording.
2 Press the SHIFT
the "Y" corresponding to the timer recording to cancel.
3 Press the SET - (or +) button, to select "N".
4 Press the MENU button three times until the normal screen is
displayed.
5 Press the POWER/TIMER button.
• The clear button can erase the programmed timer recording in the
line that the cursor is located.
Notes...
• During timer recording all the buttons on the VCR, except the STOP
button, are disabled. If the STOP button is pressed for three seconds
during timer recording, the recording will stop. During timer
recording stand-by, press the POWER/TIMER button if the buttons
do not respond.
• If there is a power loss, the recording will be interrupted. When the
power is restored, the recording will resume if the stop time has not
yet been reached, and " PF " will be flashing on the display panel.
The VCR internal battery is completely charged after the VCR has
been connected to an AC power outlet for 48 hours, and it will
maintain all the VCR settings memory for up to 30 days.
• Set the timer recordings so that the recording times do not overlap.
If they do, the one with the earliest recording start time will have
priority.
(See chart below)
• If the cassette tape is ejected while timer recording is set, the
buzzer will be heard 5 times (when the buzzer function is set to
"YES".).
18
(or ) button until the cursor is located in