Setting The Security Lock (Set Lock); Setting The Sw Out Terminal Output - Marmitek TLV 9600 Notice D'utilisation

• While the security lock is
engaged, all commands are
disabled.
• The security lock should not be
engaged while a menu is
displayed.
• If "TIMING" is set to FRAME
(see step 6), "FRAME" will be
indicated instead of "FIELD".

Setting the Security Lock (Set Lock)

The security lock function is designed to prevent accidental stopping
of recording if the STOP button is pressed inadvertently.
1 Set the SET LOCK switch to "ON" position.
• " " is displayed on the display panel.
2 To cancel the security lock, set the SET LOCK switch to "OFF"
position.
• " " will be erased from the display panel.

Setting the SW Out Terminal Output

Synchronization pulses for multiplexers can be obtained from the
SW OUT terminal.
1 Press the MENU button, to display the initial menu.
2 Press the SHIFT
OUT Terminal Set.
3 Press the SHIFT
SET menu.
4 Press the SHIFT
• With each press of the SHIFT
indicated below.
5 Press the SHIFT
6 Press the SHIFT
• FIELD . . . 1 pulse is output after each set number of fields.
• FRAME . . 1 pulse is output after each set number frames.
7 Press the MENU button, the normal screen is displayed.
• The setting procedure is now complete.
28
button to move the arrow mark( ) to SW
button to display the SW OUT TERMINAL
button to set "FIELD" (or "FRAME").
button, the setting will changes as
button, to select Timing.
button to set the "TIMING".