Normal Playback; Tracking Control; Audio Playback - Marmitek TLV 9600 Notice D'utilisation

Normal Playback

• A slow motion effect or
accelerated playback effect can
be achieved by using a slower
or faster playback speed than
the speed used for recording.
• Noise will appear in the image
when audio playback is used in
18-hour mode (NTSC) or 6,12,
18 and 24-hour modes (PAL).
Normal Playback
1 Turn on the power to the TV monitor.
2 Load the video cassette tape.
3 Press the REC/PLAY SPEED
playback speed.
• The selected playback speed is displayed on the display panel
• A tape recorded with EP heads can be played in 6-hour, 18-hour
modes
(NTSC ONLY)
• A tape recorded with SP heads can be played in 2-, 24-, 36-, 48-,
72-, 96-, 120-, 168-, 240-, 360-, 480-, 720-, 960-hour modes
.
ONLY)
• The picture quality recorded by EP heads can be lower than SP
heads
(NTSC ONLY)
• A tape recorded can be played in 3-, 12-, 18-, 24-, 36-, 48-, 72-, 96-,
120-, 168-, 240-, 360-, 480-, 720-, 960-hour modes
4 Press the PLAY button.
• Playback starts.
• If necessary, adjust the tracking to eliminate the noise from the
picture.
5 To stop playback, press the STOP button.
• To advanced or rewind the tape, press the FF/CUE or REW/REVIEW
button.

Tracking Control

If there is noise in the image during playback,
1 While looking at the playback picture, press and hold the
TRACKING + button to minimize the noise.
2 If it cannot be minimized, press the TRACKING - button.

Audio Playback

Audio playback is only possible in 2, 6 and 18-hour modes
3,12,18 and 24-hour modes
The playback speed has to be the same as the recording speed, for
normal playback of the audio.
For a tape recorded in 2, 6 and 18-hour modes
24-hour modes , to playback the audio, press the AUDIO ON
(PAL)
button after pressing the PLAY button. "A" will be displayed to the
left of the playback speed on the display panel. Press the AUDIO ON
button again to remove "A".
23
(or ) button to select the
.
.
.
(PAL)
(NTSC
.
(PAL ONLY)
or
(NTSC)
or 3,12,18 and
(NTSC)