Maintenance - Imetec L6901 Mode D'emploi

EN
CLEANSING / EXFOLIATION (4, 5, 3)
• Fit the pre-set head (Normal, Sensitive, Peeling) on the coupling
area (1C).
• Wet the skin.
• Apply the usual cleanser to the skin.
• Switch the appliance on by pressing the on/off button (1A)
select the desired rotation intensity.
• Gently slide the brush on the body, without exerting excessive pressure,
as shown in the figure [M].
• Once the treatment is complete, rinse the body and pat it dry gently.
DRY EXFOLIATION
For a more intense result, you can use the PEELING head (3) on dry skin
before bathing. In this case it is advisable to gently slide the brush on the skin
without pausing too long on the treated area, starting from the feet upwards,
following the direction of the blood flow.
PUMICE (6)
• Apply the Pumice head to the coupling area (1C).
• Carefully cleanse the area to be treated.
• Switch the appliance on by pressing the on/off button (1A)
select the desired rotation intensity.
• Slide The Pumice On The Different Areas With Gentle Circular
Movements, Without Applying Excessive Pressure.
• Once The Treatment Is Complete, Rinse The Treated Area And Pat
It Dry Gently.
After each use you must clean the appliance.
Brushes, Pumice (3,4,5,6):
• Wash with warm water and neutral soap.
• Remove the excess water with a soft, clean and dry cloth.
• Let the accessories dry completely before putting them away.
36

MAINTENANCE

and
and