Multi Camera Mode - Amplicomms Watch & Care V300 Mode D'emploi

Multi camera mode

If you registered several cameras (up to 4) to your system, you can select a
single camera or switch to scan mode. In scan mode, the signals from all
activated cameras are continuously displayed alternately each for about 10
seconds.
Press this button briefly. The number of the selected camera is
shown.
Select another camera or the scan mode by pressing this button
repeatedly.
Selecting the cameras for the scan mode
When performing the selection of the camera (see above), you can
set by pressing these buttons for each of the registered cameras,
whether it should be assigned to the scan mode (e. g. "C2 x" = not
assigned to the scan mode / "C2 ✔" = assigned to the scan mode).
For each of the four cameras you can select the features settings
individually.
Helpline UK 0844 800 6503
(See page 44 for costs and hours of operation)
O
PERATING THE
R
ECEIVER
39