Switching The Receiver On/Off; Settings - Amplicomms Watch & Care V300 Mode D'emploi

O
PERATING THE
Operating the Receiver
Check the transmitter and receiver are working properly each time befo-
re the equipment is put into operation.

Switching the receiver on/off

Press and hold this button until the logo appears first then the image
being taken by the transmitter camera.
Press and hold the button for approx. 2-3 seconds to switch the unit
off.

Settings

With the settings menu open (long press on the menu button
will get to the next setting by pressing the menu button briefly. For
changing the relevant setting press (multiple, if neccessary) the buttons
on the multi function key. If no action is detected within 5 seconds,
the device returns to idle state.
Press and hold down the menu key for approx. 3 s to access the set-
tings menu.
The display shows
Use
Press the menu key briefly.
The display shows
Use
Press the menu key briefly.
34
R
ECEIVER
.
to adjust the brightness.
.
to set temperature measurement to °C or °F.
Helpline UK 0844 800 6503
(See page 44 for costs and hours of operation)
), you