Connecting The Receiver; Setting Up The Receiver - Amplicomms Watch & Care V300 Mode D'emploi

Connecting the receiver

Attention: Position the receiver with a minimum distance of 1 m to
other electronic devices, otherwise there is a risk of mutual disturbance.
Connect the receiver as illustrated in the diagram. For safety reasons, only
use the power adapter plug supplied.
Mains power outlet
Changing the rechargeable batteries
1. Open the battery compartment on the rear side of the receiver (screwdri-
ver neccessary).
2. Take out the old battery pack and install the new one. Observe the cor-
rect polarity (charging contacts).
3. Close the battery compartment again.
The receiver is powered by a a Lithium-ion battery pack of 3.7 V,
1700 mAh. The rechargeable battery pack is recharged directly in the
receiver when the power supply is connected. The charging status
appears in the display. The more segments are shown in the symbol the
fuller the battery.

Setting up the receiver

For setting up the receiver unfold the support at the rear side.
P
UTTING THE
Helpline UK 0844 800 6503
(See page 44 for costs and hours of operation)
U O
NITS INTO PERATION
29