Range; Registration - Amplicomms Watch & Care V300 Mode D'emploi

O
PERATING THE

Range

When the distance between the transmitter and receiver is too far,
the message "Out of Range" appears in the display and you hear a
beep. Move the receiver nearer to the transmitter. If necessary, opti-
mum range can be achieved if the Parent unit antenna is extended
vertically.

Registration

In delivery state the transmitter is pre−registered at the receiver. If necessa-
ry or if a another camera is added to the system, registration can also be
completed manually:
1 Switch on the receiver.
2 Press and hold down the button
3 Use the
4 Press the
seconds. During this time, you must perform steps 5 and 6.
5 Switch the transmitter on (switch set to ON).
6 Press the registration key on the rear of the
transmitter. After a short time the video
from the transmitter will appear on the
screen if the registration was successful. If
the registration failed, "Out of Range" appe-
ars on the screen.
38
R
ECEIVER
buttons to select the desired camera [C1] ... [C4].
button briefly. The Link LED flickers for approx. 10
Helpline UK 0844 800 6503
(See page 44 for costs and hours of operation)
until [C1] appears in the display.