Assembling Your Steam Mop - shark S2901EU Notice D'utilisation

Assembling Your Steam Mop

IMPORTANT: Always make sure the mop is
UNPLUGGED from the wall when not in use. Never
fill the mop, attach the mop head, change or remove
the cleaning pocket when the mop is plugged
into the wall. To prolong the life of your Shark
Multi-Function Steam Pocket
recommend using distilled water. Make sure you
only add water to the tank. Chemicals or cleaning
solution may damage the appliance and could be
unsafe for you and your family.
fig. 1
1
®
Mop Lite we
®
2
3
STEAM MOP ASSEMBLY
Insert the Mop Handle end with the "
the front of the unit into the handheld steamer. Push
the mop handle in until you hear it click into place.
(fig. 1)
Select the Rectangle or Triangle mop head and the
desired cleaning pocket. Fit one side of the pocket
onto the head first, then using the loop, pull the
pocket over the head. Attach the quick fasteners on
the top of the pocket to secure in place.
Snap the mop head into the mop body by lining up
the groove on the back of the mop body with the
groove on the back of the mop head. Push until you
hear it latch into place. Press the release button to
remove or change the mop head. (fig. 2)
www.sharkclean.eu
fig. 2
" facing
39