Assembling Your Vacuum; Choosing The Appropriate Setting - shark Rocket HV300 Guide Du Propriétaire

ASSEMBLING YOUR VACUUM

NOTE: Before vacuuming your delicate
area rugs or carpet, refer to the
manufacturer's recommended cleaning
instructions�
7
s h a r kc l e a n . c o m
STEP 1
1
Insert the wand into
the motorized floor
nozzle connector until
it clicks into place�
CLICK
STEP 2
2 Insert the handheld
vacuum into the top
of the wand until it
clicks into place�
CLICK

CHOOSING THE APPROPRIATE SETTING

Slide the power switch on the handheld vacuum to the appropriate speed setting�
Setting I, Bare Floor, Small Area Rugs: The brushroll spins slowly to clean bare
floors and delicate area rugs�
Setting II, Carpets: The brushroll spins faster to pick up debris below the surface
of your carpets�
NOTE: For deep cleaning per ASTM F 608 (embedded dirt in carpets) please
ensure switch is set to Setting II, Carpets�
BRUSHROLL INDICATOR LIGHT
Solid Green: When the indicator light on the nozzle is green, then the brushroll is
spinning and working as it should�
Solid Red: There is a jam in the brushroll area� Turn your vacuum off and remove
any blockages in the nozzle�
No Light: The vacuum is off�
Flashing Red: The vacuum has overheated� See Troubleshooting section�
8
s h a r kc l e a n . c o m