Christopeit Sport AL 3 Notice De Montage Et D'utilisation page 21

Step 5:
Attach the saddle (20) and saddle support (26).
1. Push the saddle (20) with saddle bracket into the saddle slide (22) and
tight it up in desired position.
2. Place the saddle slide (22) into the holder of saddle support (26), set
it at the desired position and screw it onto the saddle support (26) by
screw (23) washer (24) and star grip nut (25).
3. Push the saddle support tube (26) into the matching locator in the main
frame (57), set it at the desired position and lock it by inserting the bolt
with the quick release (28) in place and doing it up tight.
(The setting of the saddle support can adjust easily as desired later
through turning and pulling the quick release (28).) Furthermore, you
must ensure when setting this desired position that the saddle support
is not pulled out of the main frame further than the highest setting posi-
tion, which is marked.
Attention: Ensure before every exercising that the saddle is tighten
firmly
Step 6:
Attach the computer (1) at support (92).
1. Put the plug of connection cable (96) into the plug from computer (1)
backside.
2. Insert the plug of pulse connection cables (12) to the jack of the computer
(1) and attach the computer (1) to top monitor bracket of front post (92)
with screws (2) which you find on backside of computer. (Attention:
Ensure that the cable loom are not crunched or pinched during instal-
lation.)
21