Picture Select - Pioneer Elite PRO-1010HD Mode D'emploi

System Settings

PICTURE SELECT

This function allows you to switch the input signal format
to automatic or manual when inputting the digital signal.
1
Press the MENU button to display the menu screen.
STANDARD
PICTURE SCREEN
:
CONTRAST 0
:
BRIGHTNESS 0
:
COLOR 0
:
TINT 0
:
SHARPNESS 0
:
MPEG NR MID
:
DNR MID
:
CTI ON
PICTURE RESET
SET ENTER
2 Use the 2/3 buttons to select [SET UP].
STANDARD
PICTURE SCREEN
PURECINEMA
CLAMP POSITION
SIGNAL FORMAT
COLOR DECODING
HDMI INPUT
BRT. ENHANCE
ENTER
SET
3 Use the 5/∞ buttons to select [HDMI INPUT], then
press the SET button.
STANDARD
PICTURE SCREEN
PURECINEMA
CLAMP POSITION
SIGNAL FORMAT
COLOR DECODING
HDMI INPUT
BRT. ENHANCE
SET ENTER
4 Use the 5/∞ buttons to select [PICTURE SELECT].
HDMI INPUT
PICTURE SELECT
AUDIO
SET
SET
26
EN
INPUT1
SETUP OPTION
MENU EXIT
INPUT1
SETUP OPTION
:
OFF
:
:
:
:
ON
EXIT
MENU
INPUT1
SETUP OPTION
:
OFF
:
:
:
:
ON
MENU EXIT
:
AUTO
:
AUTO
EXIT
MENU
5 Use the 2/3 buttons to select [PICTURE SELECT]
setting.
The unit has been factory set at the AUTO setting.
Each time you press the 2/3 buttons, the setting
changes as follows:
AUTO
COLOR4 COLOR3
AUTO: Automatically identifies input video signals.
COLOR1: Accepts Y C /P
B B
COLOR2: Accepts Y C /P
B B
COLOR3: Select COLOR3 for too dark or distorted
picture when accepts RGB signals.
COLOR4: Select COLOR4 to remove white glare in the
picture when accepts RGB signals.
Note
Even when AUTO is selected, automatic switching may not
occur properly with some input signals. In this event, select
COLOR1, COLOR2, COLOR3 or COLOR4 manually in
accordance with the actual signal input.
6
Press the SET button.
This completes [PICTURE SELECT] setting, and
returns you to the display shown in step 3.
7
After completing settings, press the MENU button
to return to the normal display.
COLOR1
COLOR2
C /P (4 : 2 : 2) signals.
R R
C /P (4 : 4 : 4) signals.
R R