Connection Panel - Pioneer Elite PRO-1010HD Mode D'emploi

Part Names and Functions

Connection Panel

Illustration depicts PRO-1010HD model.
S-VIDEO
=
SPEAKER
R
8Ω ~16Ω
+ –
1
Plasma Display Section
The plasma display is provided with 6 video input
connectors, 1 video output connector, audio input/output
jacks and speaker terminals together with a CONTROL
OUT connector for connecting to PIONEER components
bearing the Î mark.
For instructions regarding connections, consult the pages
noted in parentheses by each item.
1
SPEAKER (R) terminal
For connection of an external right speaker.
Connect a speaker whose impedance is 8 –16 Ω.
2
CONTROL OUT
For connection of PIONEER components that bear the
Î mark. Making CONTROL connection enables
control of this unit as a component in a system (page
19).
3
RS-232C
Never connect any component to this connector
without first consulting your Pioneer installation
technician.
This connector is used for plasma display setup
adjustments.
8
EN
INPUT3 INPUT4 AUDIO
VIDEO INPUT 3/4
IN OUT R L G(ON SYNC) B
~ ! @
OUT
RS-232C
CONTROL
2 3
POWER AC IN
OFF ON
9 0
INPUT5
ANALOG RGB AUDIO
R HD (H/V SYNC) VD R L
# $
ANALOG RGB IN
AUDIO
INPUT1
INPUT1
D-Sub
R
4 5
4
ANALOG RGB IN (INPUT1) (mini D-sub 15 pin)
For connecting components equipped with RGB
outputs jacks, such as a personal computer or external
RGB decoder; or components equipped with
component output jacks, such as a DVD recorder.
Make sure that the connection made corresponds to
the format of the signal output from the connected
component (pages 12 to 15). Select this INPUT or the
6
HDMI INPUT ( ) for INPUT 1 in [INPUT1 SELECT] in
the menu (page 23).
5
AUDIO (INPUT1) (RCA pin jack)
Use to obtain sound when INPUT1 is selected.
Connect this jack to the audio output connector of the
device connected to the plasma display's INPUT1 (D-
sub or HDMI (analog audio)) (page 18).
Note
The left audio channel (L) jack is not compatible with
monaural input sources.
SPEAKER L
8Ω ~16Ω
+ –
-
AUDIO
INPUT2
L R L
HDMI HDMI
6 7 8