Connection To A Personal Computer - Pioneer Elite PRO-1010HD Mode D'emploi

Note
When making G ON SYNC connections, do not make any
connections to the VD or HD jacks. If connections are made, the
picture may be not displayed normally.
Connection of composite SYNC analog RGB
source
Make composite SYNC connections for a component
with output that has the vertical synchronization signal
layered on top of the horizontal synchronization signal.
When connecting to ANALOG RGB IN (INPUT1)
ANALOG RGB IN
AUDIO
INPUT1
INPUT1
D-Sub
R L
When using D-sub INPUT for INPUT1, select [D-sub] in
[INPUT1 SELECT] in the menu (page 23).
Note
You cannot simultaneously use the HDMI INPUT and this INPUT.
On-screen setup is necessary after connection.
Please see pages 23 to 25.
When connecting to ANALOG RGB (INPUT5)
ANALOG RGB
G(ON SYNC) B R HD (H/V SYNC) VD
On-screen setup is necessary after connection.
Please see pages 23 to 25.
Note
When making composite SYNC connections, do not connect
anything to the VD jack. If connected to, the picture may not be
displayed properly.
HDMI
INPUT5
Installation and Connections
Connection to a personal
computer
Connection method differs depending on the computer
type. When connecting, please thoroughly read the
computer's operating instructions.
Before making connections, be sure to make sure that
the personal computer's power and display's main power
is off.
For the PC input signals and screen sizes that the display
is compatible with, please refer to the plasma display's
Operating Instructions.
Connection of separate SYNC analog RGB
source
Make separate SYNC connections for a personal
computer that has RGB output separated into 5 output
signals: green, blue, red, horizontal synchronization signal,
and vertical synchronization signal.
When connecting to ANALOG RGB (INPUT5)
ANALOG RGB
G(ON SYNC) B R HD (H/V SYNC) VD
On-screen setup is necessary after connection.
Please see pages 23 to 25.
INPUT5
13
EN