Publicité
Les langues disponibles
Les langues disponibles
Once you have installed the hearth, check that all joints have been sealed in
order to prevent air seeping in, which would have a negative effect on the
draw.
Before lining the hearth with bricks or any other material, make sure it
works correctly.
When lighting the hearth for the first time, it is advisable to open the
windows in order to evacuate the fumes and smells that may be caused by
the combustion of the solvents used in the protective paint or of any other
material.
5.2 REGULATING DRAW
In order to regulate fire intensity
in the H-01, turn the chimney
butterfly valve.
If you have the optional glass
door, it is advisable to open the butterfly valve completely and regulate
intensity by sliding the air intake hatch located on the front of the door
frame.
In Models H-02/22 and
TC-1, use the ash pan
(turning the handle) to
regulate intensity.
If you wish to increase the
heating
power
of
the
HEARTH, use a chisel
and hammer to open the holes located on the back of the grate. (This grate
is not provided with models H-02/22 and TC-1).
IMPORTANT!! The hearth must be closed at all times when lit to avoid
smoke from leaking out. Only open to introduce fuel.
6.- CLEANING
6.1ENAMEL CAST IRON FRONT PIECE (ACCESSORY)
Preferably clean when the HEARTH is cold. Use a damp cloth dipped in
soapy water. Avoid the use of strong detergents or abrasive products that
may damage the enamel.
- 35 -
Publicité
