Cleaning Modes - shark Navigator Zero-M Pet Pro ZU60 Série Guide D'utilisation

WHOLE-HOME CLEANING
POWER/SURFACE SWITCH
Select surface setting:
O Power Off
I Hard Floor
For bare floors and small area rugs.
II Carpet
For carpets.
BRUSHROLL INDICATOR LIGHT
INDICATOR LIGHT
WHAT DOES THE BRUSHROLL INDICATOR LIGHT MEAN?
Solid Green: The brushroll is spinning and working as it should.
Solid Red: There is a jam in the brushroll area. Turn your vacuum off, unplug from the wall and
remove any blockages in the nozzle.
Flashing Red: The motorized floor nozzle is overheating. Turn your vacuum off and wait a
minimum of 45 minutes for it to cool down.
NOTE: For deep carpet cleaning per ASTM F608 (embedded dirt in carpets), set to MAX suction and use setting II, Carpet.
sharkc le a n.com
SETTINGS
SUCTION CONTROL
Your Suction Control slider located on the top of the
handle allows you to adjust your suction depending
on your floor type.
MIN: to reduce suction and increase maneuverability
on carpets.
MAX: to increase suction on bare floors.
WHOLE-HOME CLEANING

CLEANING MODES

UPRIGHT
To engage brushroll, place foot on floor nozzle
and tilt handle back.
Handle
ABOVE-FLOOR—HANDLE
Press the Handle Release button to detach the
handle from the wand.
NOTE: All accessories are compatible with both the wand and the handle.
ABOVE-FLOOR—WAND
Press the Wand Release button to detach the
wand from the pod.
s ha r kc lea n.com