Cleaning Modes - shark Rotator Lift-Away Pet Guide D'utilisation

WHOLE-HOME CLEANING
POWER/SURFACE SWITCH
Select surface setting:
O Off
I Hard Floor
For bare floors and small area rugs.
II Carpet
For carpets.
NOTE: The brushroll spins in both modes.
BRUSHROLL INDICATOR LIGHT
INDICATOR LIGHT
WHAT DOES THE BRUSHROLL INDICATOR LIGHT MEAN?
Solid Green: The brushroll is spinning and working as it should.
Solid Red: There is a jam in the brushroll area. Turn off the vacuum and unplug it, then remove
any blockages in the nozzle.
Flashing Red: The motorized floor nozzle is overheating. Turn off the vacuum, unplug it, and
remove any blockages. Let the vacuum cool down for at least 60 minutes before restarting.
See Troubleshooting section for more information.
NOTE: For deep carpet cleaning per ASTM F608 (embedded dirt in carpets), use Carpet mode and set suction control to Max.
s h a r kc l e a n . c o m
SETTINGS
SUCTION CONTROL
Suction Control offers variable suction
based on your needs. Slide to MIN to reduce
suction and increase maneuverability on
carpets. Slide to MAX to increase suction on
bare floors.
WHOLE-HOME CLEANING

CLEANING MODES

UPRIGHT
To engage brushroll, step on nozzle and tilt
handle back firmly. Press the Power/Surface
Switch to the appropriate floor setting.
LIFT-AWAY™
Press the Lift-Away button to detach the pod
from the floor nozzle.
ABOVE-FLOOR—HANDLE
Press the Handle Release button on the back
of the wand to detach the handle from the wand.
NOTE: All accessories are compatible with both the wand and the handle.
LIFT-AWAY—WAND
With pod removed, press the Wand Release
button to detach the wand from the pod.
s h a r kc l e a n . c o m