Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Connect the green earth lead from the energiser's
fence earth terminal (green) to the earthing system.
Connect the red lead from the energiser's fence output
terminal (red) to the fence.
Connect the red lead to the fence. Provide a good
connection.
Operation
• Keep this manual in a handy location.
• Carefully read all the safety considerations starting on page 44.
• Carefully check your installation to ensure that it complies with all local safety regulations.
Select the output setting using the selector switch (see next page). One of the three output per-
formance indicator lights will flash with each pulse. The lights indicate the approximate voltage
at the fence output terminals, except when the selector switch is set to "Full power with battery
test".
Recommended
Indicates a load on the energiser. Attention required to ensure reliable animal con-
trol.
Fence is heavily loaded and needs urgent attention
If at any time all the indicator lights flash for more than 10 seconds, turn off the energiser for
approximately 10 seconds, then turn it on again. If the indicator lights continue to flash, return
the energiser to the nearest authorised service agent.
The energiser functions according to the position of the power output and pulse speed swit-
ches. See the diagram of the energiser on page 35.
- 37 -
Joint clamp
Energiser
Earth system
Publicité
Table des Matières
