Darning; Setting Memory Darning Size; To Adjust The Evenness Of Darning - ELNA eXperience 540 Mode D'emploi

q
zxc
q
w
y
(d5) (d4)
(–)
w e
e
r
v
t
u
(d6) (d5)
(+)

Darning

Machine Settings
q Pattern:
w Presser foot:
e Needle thread tension: 1–6
Extend the buttonholder q completely open. Place
both threads to the left under the foot. Insert fabric
under the foot and lower the needle at the starting
point w. Lower the foot. Sew.
The size of one darning cycle is variable.
However, the maximum darning cycle length e is
2 cm (3/4˝) and the maximum darning cycle width
r is 7 mm (1/4˝).
To sew another darning cycle with same size —
raise foot, move fabric, lower foot and sew when the
dot is blinking t.
Repeat sewing in a different direction until the
darning covers the rip or hole.

Setting memory darning size

To darn a length less than 2 cm (3/4˝) u, stop the
machine after sewing the desired length and press
the Reverse key y. The darning length has now
been determined. Restart and sew until the
machine stops automatically.

To adjust the evenness of darning

Fabric and the number of layers can affect darning.
If one side of darning is higher or lower than the
other, make them even by pressing the
If left corner is lower than right side, press
If left corner is higher than right side, press
NOTE: d5 is default setting. Evenness can be set
between d1 and d9.
66
#09
Automatic buttonhole foot R
or
.
.
key.