1/4" Seam Foot (Without Guide) (O); Darning Foot (Open-Toe) (Pd-H) - ELNA eXcellence 780 Mode D'emploi

1/4" Seam Foot (without guide) (O)

Achieve perfect 1/4" seam allowance along the edge of the foot. A great tool for quilt piecing.
Make sure to press the Lockout key when attaching and detaching the foot.
Machine Settings
Stitch pattern:
Thread tension: [Auto] or 3 - 5
Stitch length: 1.5 - 2.0
To Sew
Align the fabric edge with the right edge of the foot as shown in (A).
Lower the foot and sew while guiding the fabric edge along
the right edge of the foot. You can sew scant 1/4" piecing.
Aligning the guide line with the 1/4˝ guide of the foot, you can sew
a 1/4" allowance from the guide line as shown in (B).
* The foot has 1/4" (1) markings at the front and behind from the
needle drop position as shown in (C).
Use these markings to start and stop to sewing.

Darning Foot (open-toe) (PD-H)

This foot has great visibility around the needle area and multiple uses such as free motion quilting, making
basting stitches and so on.
Make sure to press the Lockout key when attaching and detaching the foot.
Machine Settings (for free motion quilting)
Stitch pattern: Straight stitch (center needle position)
Thread tension: [Auto] or 3 - 5
Feed dog: Down
To Attach
Raise the needle and presser foot.
Remove the foot holder and attach the darning foot to the presser
bar with the pin over on the needle clamp screw.
Secure the foot with the setscrew.
To sew (for free motion quilting)
Draw a quilt design on the fabric with a washable marker.
Guiding the fabric with your hands, sew while tracing the design at
slow to medium speed.
* Move the quilt layers 3 mm (1/8˝) or less per stitch.
* Do not move or pull the quilt layers toward you suddenly or with
force because this may cause the needle to break.
Caution
(A)
Caution
4
1/4" guide
(C)
O
q
q
Markings*
q q
Pin
Setscrew
Presser bar
(B)
O
Guide line
Needle drop
position
Needle
clamp screw