Names And Functions Of Parts (Main Unit) - Teac AI-503 Mode D'emploi

A B C
A
POWER switch
Use to turn the unit on and off .
o If all the input indicators are dark even though the POWER
switch is set to ON, the cause is usually one of the following .
i The remote control STANDBY/ON button has been
pressed or the automatic power saving function has acti-
vated, putting the unit into standby .
i The power cord is disconnected .
To turn the unit on from standby, press the remote control
STANDBY/ON button, or set the POWER switch to OFF once
and then back to ON .
B
Audio input (IN — LINE 2/OPT 2)
Use this to input audio (page 10) .
Analog: Use a cable with a 3 . 5 mm stereo mini plug .
Optical: Use an optical cable with a mini plug .
C
PHONES jack
Connect headphones (3 . 5 mm stereo mini plug) here (page 11) .
o This headphone amp circuit uses a four-pole connector with
independent left and right for grounding . Ordinary plugs
with 3 or 4 poles can be used .
o If headphones are connected here, audio will not be output
from the speaker (SPEAKERS) terminals or preamp audio
output (PRE OUT) connectors on the back of the unit .

Names and functions of parts (main unit)

D E F G H
D
GAIN button
Use to switch the headphone amp gain .
E
INPUT SELECTOR knob
Use to select the input source .
The indicator lights next to the selected input source .
The indicators blink to show when the filter is being changed
and audio is muted, for example .
o Press when (Bluetooth) is selected to enable pairing .
F
Input source indicators
G
Remote control signal receiver
This receives signals from the remote control . When operat-
ing the remote control, point it at the remote control signal
receiver .
H
Level meters
These show the output levels .
I
VOLUME knob
Use to adjust the volume output from connected speakers or
headphones . Turn right to increase and left to decrease the
volume .
I
13
EN