Front Panel Controls And Their Functions - Teac A-H500 Manuel Du Propriétaire

Front Panel Controls and Their Functions

3
2 1
1Power standby/on button
When the main power switch on the rear
panel is ON:
Press this button to turn the power on, and
the whole system connected by the remote
control connection cables is turned on.
Press it again to turn the system off (power
standby mode).
Note:
The system cannot be turned on when the
main power switch on the rear panel is
OFF.
2Power standby indicator
This indicator lights up in the power
standby mode and goes out when this unit
is turned on.
3Remote control signal sensor
This sensor receives the signal from the
remote control transmitter.
4Record selector
Set this selector to the appropriate position
before beginning recording.
source:
Set the selector to this position to record
the radio broadcast, CD, record or auxiliary
source.
off:
Set to this position when you do not
record.
4
w q
tape 1∏2/MD:
Set to this position to record from the
cassette deck 1 to 2 or MD recorder.
MD/tape 2∏1:
Set to this position to record from the MD
player or cassette deck 2 to 1.
5Volume control
This control is used for adjusting the signal
output level to the speakers.
6Input selector
Rotate this selector to select the desired
input source.
MD/tape 2:
For listening to the sound from the unit
connected to the MD/TAPE 2 jacks on the
rear panel.
tape 1:
For listening to tape.
CD:
For listening to CD.
tuner:
For listening to radio broadcast.
phono:
For listening to record.
aux:
For listening to the sound from the unit
connected to the AUX jacks on the rear
panel.
7CD direct indicator
This indicator will light up when the CD
direct function is engaged.
5
0 9
_ 6 _
6
8 7
8CD direct button
Press this button for the pure sound when
you listen to the CD, and then the tone and
balance controls are bypassed.
Press it again to resume the controls.
Note:
When the CD direct function is engaged,
no signal is output to the TAPE REC
outputs. Therefore, when recording, set
the CD direct button to OFF (the indicator
above the button is unlit).
9Treble control
This control is used for adjusting the level
of the high frequency sound range.
0Bass control
This control is used for adjusting the level
of the low frequency sound range.
qBalance control
This control is used for adjusting the
balance of the volume level between the
left and right channels.
wHeadphones jack (phones)
Connect the headphones plug to this jack
for listening through headphones.
Sound from the speakers will not be heard
when headphones are connected to this
jack.
Note:
Decrease the volume level to minimum
(∞position) before connecting head-
phones.